RGBlink
← Back to Support Hub
proAV

Support For Integrators & Commercial Installations

What we can help with

processor control, video routing, installation design, integration issues, and OpenAPI questions for proAV devices.

  • Commercial installations, processors, switchers, scalers, and distribution systems
  • OpenAPI control questions for proAV devices
  • System integration, deployment, and troubleshooting across installed projects

Start a support chat

Tell us your device model and what you need help with, or try a suggested question.

Support Knowledge

Select an article from the menu to view full content here.

General / cameraCMS / Device Configuration

cameraCMS Configuration Steps

📢  Applicable Model: RGB20X-NAI-GY Educational Tracking Camera (order codes: 981-0011-21-0).

After downloading the software, double-click the application icon to launch CameraCMS.

Find Your Device

In the main interface, open Device Management page.

Step 1: Search for Cameras

  1. Click Start Search and wait for the software to detect the camera.

    The detected device will appear in the search results.

Document image

  1. Select the detected camera and click Modify netinfo to reconfigure its IP settings if necessary.

    Save the changes and reboot the camera if the IP settings are modified.

Document image

Step 2: Add the Cameras

  1. Click Add to client to add the camera to Device Management.

  2. In the Add pop-up window, ensure that the camera's IP address and the LAN configuration are on the same network segment.

  3. Click Add to confirm. The camera will then appear in the Device Management list.

📢  Notes: No username or password is required by default.

Document image

  1. In the Device Management list, select the camera and confirm that it is highlighted in blue and its status is Connected.

  2. Click Remote configuration to proceed to the next step.

Document image

Remote Configuration

In the Remote configuration window, open the Protocol tab and configure the following settings:

  1. Enable: Select Enable to activate the protocol.

  2. Protocol: Select UDP or TCP according to the camera controller's requirements.

📢  Notes: Use UDP with RGBlink mini-series devices.

  1. Camera as: Leave the setting at Client by default.

  2. Ip: No configuration is required for this field.

  3. Port: Enter the port number configured for VISCA or PELCO, as applicable.

    The default VISCA port is 1259.

📢  Notes: Do not use the following ports, as they are reserved by the camera's internal services: 
5000, 5002, 554, 80, 88, 8080, and 9005.
  1. Click Save then rebot the camera to apply the settings.

Document image

Main View

Click Main View to access the camera preview and operational controls.

Document image

  1. In the Device list, double-click the camera to display its video feed.
  2. Click the button in the bottom-left corner to start or stop AI object tracking.
  3. Click Settings to configure AI object bounds.

Document image