RGBlink
← Back to Support Hub
proAV

Support For Integrators & Commercial Installations

What we can help with

processor control, video routing, installation design, integration issues, and OpenAPI questions for proAV devices.

  • Commercial installations, processors, switchers, scalers, and distribution systems
  • OpenAPI control questions for proAV devices
  • System integration, deployment, and troubleshooting across installed projects

Start a support chat

Tell us your device model and what you need help with, or try a suggested question.

Support Knowledge

Select an article from the menu to view full content here.

FAQ / Q16pro / Save And Load Pages

Q16pro gen2 1U save and load pages

Overview

Q16pro Gen2 1U can store and recall up to 256 scenes, but the page workflow is not obvious if you only stay inside Layer view.

Applies to

Q16pro Gen2 1U

Prerequisites

  • Use firmware V1.42 or later on the processor.
  • Use XPOSE V2.0.7.7 or later.
  • Connect the PC and processor by network cable or serial cable.
  • If you use Ethernet, keep both devices in the same network segment. The factory default processor IP is 192.168.0.100.

Save a page

  1. Build the container in Display and create the scene layout in Layer.
  2. If you need more than the first 16 scenes, move into Scenes and open the settings control there.
  3. Use Page > Save Page to store the current layout.
  4. Return to Layer, build the next scene variation, then return to Scenes and save it to another page.
  5. Saved pages show as green in the interface.

Load a page

  1. Go to Scenes.
  2. Choose Page > Load Page.
  3. The active page shows red while saved but inactive pages remain green.

Switch scene on air

  1. Open Take Setting.
  2. Select the scene you want to switch.
  3. Click CUT to execute the switch.

References