Overview

🔔  Current XPOSE 2.0 Version:2.0.8.17

Configuration and control of RGBlink proAV devices is undertaken from RGBlink XPOSE 2.0 software.

Where to Download XPOSE 2.0

Download XPOSE using either of the following methods.

Method 1: Download from the official website

1. Visit the Official RGBlink Website.
2. Search for XPOSE.
3. Locate the Downloads section on the product page.
4. Click the corresponding download button.

Method 2: Download from the Support page

1. Visit the official RGBlink website and open the Support page.
2. Click Get Support under the proAV section.
3. On the support page, locate and expand the Software section.
4. Find XPOSE in the list and download the software.

Method 3: Download from the APPS section

1. Visit the Official RGBlink Website.
2. Scroll to the footer and click XPOSE under APPS.
3. The website redirects to the Support page > Software section.
4. Find XPOSE in the list and download the software.

System Requirements

Windows

• CPU / Processor: i5 1GHz or above (32 bit or 64 bit processor)
• Memory: minimum 4GB
• Graphics: Direct X9 128M or above (open AERO effect)
• Hard Disk: minimum 16GB (primary partitions, NTFS format)
• Display: minimum resolution of 1920×1080
• Operating system: Window 11 recommended (Windows 7, 8, 10 supported). Ghost, compact, Hyper-V, VPS installationa not supported.

Mac

• Monitor: Resolution must be 1680×1050 pixel or above

Installation

Windows

Run the installer with Administrator privileges and follow the prompts.

• The Administrator privileges allow the installation of the Virtual Comm Port that is used to connect to RGBlink devices.
• LAV Filters is installed as part of the process an is required for XPOSE.

Connection

For most device connectionto RGBlink proAV devices there are two options

• Ethernet/LAN (typical, computer and device must be on same subnet)
• Serial (requires USB to Serial Adapter for most computers, and requires D9 to RJ6 cable)