RGBlink
← 返回支持中心
proAV

系统集成与商业项目支持

查看支持范围

如问题涉及处理器控制、视频路由、安装设计、集成问题或 proAV 设备 OpenAPI，请从这里开始。

  • 商业安装、处理器、切换器、定标器和分发系统
  • proAV 设备 OpenAPI 控制问题
  • 已落地项目中的系统集成、部署和故障排查

开始支持对话

告诉我们您的设备型号和问题，或选择一个示例问题。

支持知识

从左侧目录选择文章后，在此查看完整内容。

FAQ / TAO / TAO 1mini NDI Setup

TAO 1mini NDI encode and decode setup

Overview

If TAO 1mini is not encoding or decoding as expected, the issue is usually in mode selection rather than hardware failure.

Applies to

TAO 1mini

How to enable NDI encode

  • Press and hold the NDI encode icon to enter the settings screen.
  • Complete the required settings first.
  • Return to the main workflow and press the NDI encode icon again to start encoding.

How to enable NDI decode

  • Use the left and right arrows to switch to the NDI decode page.
  • Press and hold the NDI decode icon to scan for available NDI sources.
  • Swipe to select the required source.
  • Confirm the selected NDI source, channel name, and current IP information shown in the upper area of the interface.

If it still does not work

  • Re-check the network path used for source discovery.
  • Reconfirm that the selected page is decode mode rather than encode mode.
  • Test with a single known-good NDI source before adding more sources to the network.

Reference